Embalming
is the process of chemically treating a dead body, developed by the ancient
Egyptians, and preserving a person’s body after death to delay the
decomposition, restore it to an acceptable physical appearance and reduce the
presence and growth of bacteria to prevent foul smell as well as perfume or add
fragrance to corpse. Embalming certificate is required by law in certain
circumstances like air/rail transportation.
- The
process of embalming has a very long history, dating back to the Egyptian
process of mummification. Though their techniques were quite different
from those used today, the effect was the same — to preserve an
individual’s body after death. The ancient Egyptians believed that the
spirit would return to the body after death, so it must remain in good
condition. To preserve the corpses, they covered bodies in a drying
chemical called natron, and then wrapped them in linen sheets.
- Today,
embalming is done by injecting chemicals directly into the bloodstream to
preserve the corpse’s appearance. The most commonly used chemicals for
embalming are formaldehyde and ethanol. A combination of these two
chemicals is sufficient to preserve the body for a short time i.e. up to a
week.
- To
keep the corpse in a good condition for a longer period i.e. up to a
month, a solution made up almost entirely of formaldehyde is used.
- There
are several steps involved in modern embalming. First, the embalming fluid
is injected directly into the deceased’s blood vessels, and pushed through
the body with a mechanical pump. Next, the internal organs are hollowed of
their contents and filled with embalming fluid. The chemicals are then
injected beneath the skin wherever necessary, followed by a final surface
embalming on injured areas of the body.
- One
of the most famous embalmed corpses today is that of Russian communist
leader Vladimir Lenin, whose embalmed corpse is on display at the Red
Square mausoleum in Moscow. The corpse is very well-preserved, and should
last for at least another hundred years.
No comments:
Post a Comment